Evaluating System-Level Test Generation for Industrial Software: A Comparison between Manual, Combinatorial and Model-Based Testing

Adequate testing of safety-critical systems is vital to ensure correct functional and non-functional operations. Previous research has shown that testing of such systems requires a lot of effort, thus automated testing techniques have found a certain degree of success. However, automated testing has not replaced the need for manual testing, rather a common industrial practice exhibits a balance between automated and manual testing. In this respect, comparing manual testing with automated testing techniques continues to be an interesting topic to investigate. The need for this investigation is most apparent at system-level testing of industrial systems, where there is a lack of results on how different testing techniques perform with respect to both structural and system-level metrics such as Modified Condition/Decision Coverage (MC/DC) and requirement coverage. In addition to the coverage, the cost of these techniques will also determine their efficiency and thus practical viability. In this paper, we have developed cost models for efficiency measurement and performed an experimental evaluation of manual testing, model-based testing (MBT) and combinatorial testing (CT) in terms of MC/DC and requirement coverage. The evaluation is done in an industrial context of a safety-critical system that controls several functions on-board the passenger trains. We have reported the dominant conditions of MC/DC affected by each technique while generating MC/DC adequate test suites. Moreover, we investigated differences and overlaps of test cases generated by each of the three techniques. The results showed that all test suites achieved 100% requirement coverage except the test suite generated by pairwise testing strategy. However, MBT-generated test suites were more MC/DC adequate and provided a higher number of both similar and unique test cases. Moreover, unique test cases generated by MBT had an observable affect on MC/DC, which will complement manual testing to increase MC/DC coverage. The least dominant MC/DC condition fulfilled by the generated test cases by all three techniques is the ‘independent effect of a condition on the outcomes of a decision’. Lastly, the evaluation also showed CT as the most efficient testing technique amongst the three in terms of time ted outcomes.